surface finish symbol in the title block NX10/11
surface finish symbol in the title block NX10/11
(OP)
Hello all,
I'm searching for a way to add the surface finish symbol nicely to a cell of the title block,
i know that there are some default symbols in the user defined, butt if a want to change the global tolerance value then it isn't looking nice.
so a image or custom symbol is not a option.

Does anyone haves the same problem?
I'm searching for a way to add the surface finish symbol nicely to a cell of the title block,
i know that there are some default symbols in the user defined, butt if a want to change the global tolerance value then it isn't looking nice.
so a image or custom symbol is not a option.

Does anyone haves the same problem?
Ruud van den Brand
pre-sales Consultant
cards PLM Solutions B.V.




