NX11 Sketch Options
NX11 Sketch Options
(OP)
Hi all,
We're upgrading from NX10 to NX110 and of course there're some challenges. When I open Sketch(Direct or Task) the new window doesn't have the same kinds of options as before. In NX10 we could choose a plane and then choose direction and origin options. In NX11 it's just pick a plane and get what it gives you. Any way to get the NX10 options in NX11?
John
We're upgrading from NX10 to NX110 and of course there're some challenges. When I open Sketch(Direct or Task) the new window doesn't have the same kinds of options as before. In NX10 we could choose a plane and then choose direction and origin options. In NX11 it's just pick a plane and get what it gives you. Any way to get the NX10 options in NX11?
John





RE: NX11 Sketch Options
RE: NX11 Sketch Options
All options are within the roll down menus
Regards
Didier Psaltopoulos
http://www.psi-cad.fr
RE: NX11 Sketch Options
I think the tool is working better then before. It's not necessary to switch the plane method to new plane. From the inferred you can reselect also your new plan, horizontal reference and origin point. See movie.
Ruud van den Brand
NX pre-sales Consultant
cards PLM Solutions B.V.