Abaqus : SSD Modal Analysis Boundary conditions
Abaqus : SSD Modal Analysis Boundary conditions
(OP)
Hello,
I am performing a SSD Modal Analysis on a plate and I do not know if I need to specify any boundary conditions in this step? This step is preceded by the frequency modal analysis step in which I specified my boundary conditions for my plate (that is free rotations)
Thanks in advance again :)
I am performing a SSD Modal Analysis on a plate and I do not know if I need to specify any boundary conditions in this step? This step is preceded by the frequency modal analysis step in which I specified my boundary conditions for my plate (that is free rotations)
Thanks in advance again :)





RE: Abaqus : SSD Modal Analysis Boundary conditions
BC created in a perturbation step only acts within them.
BC in nonlinear steps propagate automatically to the next steps.
RE: Abaqus : SSD Modal Analysis Boundary conditions