SAVE AS NX11
SAVE AS NX11
(OP)
Hi All,
I'm a native NX11 user. When I try to perform a SAVE AS I'm prompted what new filename the NEW file should have and in sequence the new filenames off open masters are prompted.
In NX10 I could see which master I was renaming in the status bar.
I can't see this in NX11?
Lars
I'm a native NX11 user. When I try to perform a SAVE AS I'm prompted what new filename the NEW file should have and in sequence the new filenames off open masters are prompted.
In NX10 I could see which master I was renaming in the status bar.
I can't see this in NX11?
Lars
Lars
NX10.0.3.5 native
Solid Edge
Inventor





RE: SAVE AS NX11
thread561-356704: NX9 Save as
www.nxjournaling.com