if anyone is using a Mitsubishi 3015ex s laser i would like some advice on cutting conditions for 12 gaug galv I had a reply for Jacobson thx. no pdf book .this shop only lasers galv steel and only running Ox I know in the book said 2 nozel with 7 lens then that was it .if ther is a book to use to get me close then I can adjust cnditions as I go . thx
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Since the later 1980s, manufacturing companies have seen over 3 percent in labor output year on year, with most of this productivty enhancement occuring because of the optimization of repetitive tasks. Download Now