Adjust Gap Between Part View and Dimension Line Nx10
Adjust Gap Between Part View and Dimension Line Nx10
(OP)
Hello,
Does anyone know how to adjust the spacing between the drafting view and the dimension line in Nx10? In past versions this was done using Preferences->Annotation->Line/Arrow: and adjusting the H and J values. I cannot figure out where to do this in version 10.
Thanks in Advance
Does anyone know how to adjust the spacing between the drafting view and the dimension line in Nx10? In past versions this was done using Preferences->Annotation->Line/Arrow: and adjusting the H and J values. I cannot figure out where to do this in version 10.
Thanks in Advance





RE: Adjust Gap Between Part View and Dimension Line Nx10
www.nxjournaling.com
RE: Adjust Gap Between Part View and Dimension Line Nx10
Thanks again Cowski