Fastener Alternates
Fastener Alternates
(OP)
Hello, I am inquiring about an alternate P/N to HL62-PB70-6-4 and HL63***** these being the first oversize. I have been looking around and i cant seem to find an alternative. I have found that BACB30FP and BACM30FQ respectively to be the alternates but i cannot find a site or on My Boeing fleet to confirm this. Any suggestion would be helpful. Does anyone have or know a complete conversion sheet for the pins that correspond to the collars.





RE: Fastener Alternates
Short answer: Go to the HL pin website and MOST of Your questions can be answered... although not all... but a good start.
NOTES.
Do NOT mix titanium and steel/CRES pins due to significant differences in STIFFNESS [steel/CRES pins OK to mix due-to similar stiffness's].
Download the spec page for parts that look like what You need.
Ask this question, again, if necessary AFTER reviewing what is available.
LISI HL Pins [scroll-down] - http://www.lisi-aerospace.com/products/fasteners/e...
LISI HL Collars [scroll-down] - http://www.lisi-aerospace.com/products/fasteners/i...
The HL pins listed are generally available in all diameters [up to ~0.500-OS]... but NOT all grip lengths may exist.
Regards, Wil Taylor
o Trust - But Verify!
o We believe to be true what we prefer to be true. [Unknown]
o For those who believe, no proof is required; for those who cannot believe, no proof is possible. [variation,Stuart Chase]
o Unfortunately, in science what You 'believe' is irrelevant. ["Orion", Homebuiltairplanes.com forum]