HARD MESH
HARD MESH
(OP)
Hello,
I am new using solidworks simulation and i am stuck with some questions.
I have a very complex model formed by 2 parts. Thermal analysis. It´s a reinforced concret block with a very elaborated steel grid. My model as hundreds of intersections and tiny places.
I already mesh de steel grid with curvature control bur i cant mesh the two parts together.
1- Is thr any way to mesh separated parts and tehm put them togehter ?
2 - Should i do any operation to deal with the tiny places ? like auto adjust geometry, special mesh ? ...
Thanks so much in advance.
I am new using solidworks simulation and i am stuck with some questions.
I have a very complex model formed by 2 parts. Thermal analysis. It´s a reinforced concret block with a very elaborated steel grid. My model as hundreds of intersections and tiny places.
I already mesh de steel grid with curvature control bur i cant mesh the two parts together.
1- Is thr any way to mesh separated parts and tehm put them togehter ?
2 - Should i do any operation to deal with the tiny places ? like auto adjust geometry, special mesh ? ...
Thanks so much in advance.






RE: HARD MESH
Scott Baugh, CSWP
FAQ731-376: Eng-Tips.com Forum PoliciesGryphon Environmental
www.2gryphon.com