NX 10 wide edge lines displayed on pre NX 10 data
NX 10 wide edge lines displayed on pre NX 10 data
(OP)
Referring to this preferences change for new settings that came about in NX 10: thread561-403588: NX10 - wide lines
Is there a way to have older (pre NX 10) files reset to the new line defaults automatically when you use the files in new NX 10 assemblies/drawings? My users are getting tired of having to go in and reset those line widths.
Is there a way to have older (pre NX 10) files reset to the new line defaults automatically when you use the files in new NX 10 assemblies/drawings? My users are getting tired of having to go in and reset those line widths.




