×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Drill Bit Cut

Drill Bit Cut

Drill Bit Cut

(OP)
Hello Users:

I'm looking to model a drill bit. I have been struggling with the sweep cut so I am not sure how to go about this routine.
If someone could explain the required steps or e-mail me a model, it would be appreciated.

-Caper-
gross@micro-optics.com

RE: Drill Bit Cut

just curious on how you made out...

I have done this type of work before for some of my Demo's  were you able to complete the drill bit?

Regards,
Jon
jgbena@yahoo.com

RE: Drill Bit Cut

(OP)
The drill bit that I was looking for was an end mill and that is the model I found on 3dcontentcentral.com. I had to change a couple of dimensions to get what I was looking for.

The key command I was missing was the helix/spiral command.

I'm a happy camper! )

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources