Technical drawings for Avid BB7
Technical drawings for Avid BB7
(OP)
Hi-
I'm designing and building a bike frame and have been going nuts trying to get the technical drawings for the Avid BB7.
I saw a previous thread on this, but there was never a usable conclusion. SRAM is LESS then amiable.
I need the proper angle to set the caliper body (in relation to the axle stays) and the elevation for a 200 mm disc.
Can anyone help?
Big Thanx! in advance.
-SaMo
I'm designing and building a bike frame and have been going nuts trying to get the technical drawings for the Avid BB7.
I saw a previous thread on this, but there was never a usable conclusion. SRAM is LESS then amiable.
I need the proper angle to set the caliper body (in relation to the axle stays) and the elevation for a 200 mm disc.
Can anyone help?
Big Thanx! in advance.
-SaMo





RE: Technical drawings for Avid BB7
Link
Chris, CSWP
SolidWorks '16
ctophers home
SolidWorks Legion