NX9 DATUM SYMBOL ISSUE
NX9 DATUM SYMBOL ISSUE
(OP)
In NX9 when creating a pdf of a drawing, the filled datums symbols are not appearing filled in the pdf as they are on the drawing.
We create our pdfs of drawings with a journal. I have also exported a pdf of a sheet and of the current display with the same results.
They appear as shown in attached pdf. Anybody have any thoughts on what would be causing this?
We create our pdfs of drawings with a journal. I have also exported a pdf of a sheet and of the current display with the same results.
They appear as shown in attached pdf. Anybody have any thoughts on what would be causing this?
Wayne Huseby
Drafting Checker/Drafter
United Technologies Aerospace Systems
Jamestown, ND 58401





RE: NX9 DATUM SYMBOL ISSUE
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5
HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5
RE: NX9 DATUM SYMBOL ISSUE
We create our pdfs of drawings with a journal. I have also exported a pdf of a sheet and of the current display with the same results.
They appear as shown in attached pdf. Anybody have any thoughts on what would be causing this?
Attached is the pdf.
Wayne Huseby
Drafting Checker/Drafter
United Technologies Aerospace Systems
Jamestown, ND 58401