Link CP_Part to NX Column Attribute?
Link CP_Part to NX Column Attribute?
(OP)
I am trying to integrate Teamcenter information into NX so I can use it when I am filtering / sorting assemblies. I would like to determine if a part in the assembly navigator is a make part vs. buy part. I am trying to figure out if I can create an attribute that is placed on each part that I could then use in the columns of the assembly navigator. Any ideas? Essentially I would like to take any attribute in the teamcenter foundation and link it to the nx model I am currently working on.





RE: Link CP_Part to NX Column Attribute?