3D extend spline
3D extend spline
(OP)
Hello,
I am new on NX 7.5 and I have a bit of truble to get a nice surface to make a cut on a solid.
my surface end was irregular so I trimmed it with plane and now I would like to extend the "trimmer curbe" but according to bottom extension that goes 3D.
So is this possible?
Many thanks
and pic. http://files.engineering.com/getfile.aspx?folder=5...
I am new on NX 7.5 and I have a bit of truble to get a nice surface to make a cut on a solid.
my surface end was irregular so I trimmed it with plane and now I would like to extend the "trimmer curbe" but according to bottom extension that goes 3D.
So is this possible?
Many thanks
and pic. http://files.engineering.com/getfile.aspx?folder=5...




