Max stress/max deformation output parameter -plotting the results
Max stress/max deformation output parameter -plotting the results
(OP)
Hi all,
I defined in Workbench 15 one input parameter - mesh relevance and two output parameters - max von Mises stress and max total deformation.
Is it possible to somehow plot the contours of whole analyzed geometry within all the input parameters or do I have to duplicate the analysis as many times as I set different values of input parameter?
Regards,
Maciek
I defined in Workbench 15 one input parameter - mesh relevance and two output parameters - max von Mises stress and max total deformation.
Is it possible to somehow plot the contours of whole analyzed geometry within all the input parameters or do I have to duplicate the analysis as many times as I set different values of input parameter?
Regards,
Maciek




