Catia20, Decreasing length of model by removing volume
Catia20, Decreasing length of model by removing volume
(OP)
I need to decrease the overall length of a bracket.
I want to do this by removing a 1.5mm long section which is in the center of the bracket. Is there a way to do this?
I want to do this by removing a 1.5mm long section which is in the center of the bracket. Is there a way to do this?





RE: Catia20, Decreasing length of model by removing volume
Drew Mumaw
www.textsketcher.com
www.drewmumaw.com