NX 8.5, CAM module, Tool Path vs Machine Code Simulate
NX 8.5, CAM module, Tool Path vs Machine Code Simulate
(OP)
Hello,
First of all I would like to say hello to all of you - this is my very first post at this forum. I hope that I will be able to help some of you basing on (pretty small) knowledge ;)
I am taking my first steps in Manufacturing module in NX 8.5. Right know I would like to simulate a machining process using machine code simulate function. The problem is that machine code simulation and tool path simulation don't seem to be align with each other ( You may notice the problem at the attached printscreen). Not sure if I am right but it seems that one of the coordinate system is displaced. Anyone could give me some advise how to deal with this kind of issue? I hope that attached screens will fully discribe the problem. Thank You in advance for Your help.
[img http://prntscr.com/b2vkfa]
[img http://prntscr.com/b2vlh8]
First of all I would like to say hello to all of you - this is my very first post at this forum. I hope that I will be able to help some of you basing on (pretty small) knowledge ;)
I am taking my first steps in Manufacturing module in NX 8.5. Right know I would like to simulate a machining process using machine code simulate function. The problem is that machine code simulation and tool path simulation don't seem to be align with each other ( You may notice the problem at the attached printscreen). Not sure if I am right but it seems that one of the coordinate system is displaced. Anyone could give me some advise how to deal with this kind of issue? I hope that attached screens will fully discribe the problem. Thank You in advance for Your help.
[img http://prntscr.com/b2vkfa]
[img http://prntscr.com/b2vlh8]




