PB 9.0 - Circular Motion
PB 9.0 - Circular Motion
(OP)
My post is in the notching mode (XZ) moves for cutting a radius.
I have the following filled out on the "Circular Move" data definitions page:
G94
G02
G90
X
Z
R
F
Also, on the machine tool page, I have checked "Output Circular Record"
I would appreciate any ideas to help.
Thanks.
I have the following filled out on the "Circular Move" data definitions page:
G94
G02
G90
X
Z
R
F
Also, on the machine tool page, I have checked "Output Circular Record"
I would appreciate any ideas to help.
Thanks.





RE: PB 9.0 - Circular Motion
My "Motion Output" in the Machine Control Group was set to "Linear"