how to get point co-ordinates in NX10 drafting
how to get point co-ordinates in NX10 drafting
(OP)
Hello,
I want to show the point co-ordinates i.e.
X=....
Y=....
Z=....
in drafting.
as shown in attached image. which is easiest way to do the same.
Thanks in advance.
I want to show the point co-ordinates i.e.
X=....
Y=....
Z=....
in drafting.
as shown in attached image. which is easiest way to do the same.
Thanks in advance.





RE: how to get point co-ordinates in NX10 drafting
Please try below steps.
Measure Point - Modeling Application
Tabular Note - Drafting Application
Import Expression - (MB3 in Cell) Drafting Application
regards,
Mathi Krishnan
NX10.0.1.4 D4