I have recently taken over the maintenance of a system that has four old Modicon 612 or 512 micro PLC's. I am using ProWorx 32. I have been able to write some changes to the PLC's, but what I can't do is monitor what the logic is doing in run mode. If I could just monitor the status of a few addresses at a time it would help. Does anyone have any experience with these?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
By implementing a new 3D CAD tool, top-performing manufacturers can reduce their development time by 19 percent and development costs by 15 percent. Most importantly, engineers can increase iterations by 14 percent â€” leading to more innovation and competitive advantages. Download Now