Multiple Configurations of the Same Part
Multiple Configurations of the Same Part
(OP)
Is it possible to have different configurations of the same part in Catia? I have searched this and found other postings but I couldn't find any that fit what I am talking about. I have a pop rivet that I need to model complete in order for the views to show it correctly on the print. However, when I place it in my assembly model I need it to be shorter with the tip broken off like a pop rivet looks after it has been installed. I come from twenty years of Pro/E and this would have taken about five minutes to do there but I cannot figure out how to do this in Catia. That is not meant to be a shot at Catia and I DO NOT want to start a flame war about Catia vs. CAD-system-of-your-choice it was just a statement to maybe indicate how frustrating this is becoming for me. Thanks in advance for any help.





RE: Multiple Configurations of the Same Part
Use Scenes to toggle show/no-show states.
RE: Multiple Configurations of the Same Part