How to add a point mass to a deformable rod
How to add a point mass to a deformable rod
(OP)
I have a very thin rod, one end of which is hinged and on the other end, a 1 kg mass is attached. The rod rotates about the hinged end. How can I model the 1Kg mass (basically it's a point mass) in ABAQUS





RE: How to add a point mass to a deformable rod
*********************************************************
Are you new to this forum? If so, please read these FAQs:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083