NX10: Is there script to get a report of the Max and Min value of Wall Thickness of shelled part
NX10: Is there script to get a report of the Max and Min value of Wall Thickness of shelled part
(OP)
Hi All,
Is there a script that can be run on a shelled geometry to get the report of the Max and Min Value of the wall thickness and the zone(s) where this is found. The Zone can be shown on the screen, but the Max and Min value reported in a Information window?
I know geometry property does it or Wall thickness analysis does it.. But they all give a range, not exact value ..
This is going to be used on a solid created by B surfaces.Like a housing
Thanks for the help..
Is there a script that can be run on a shelled geometry to get the report of the Max and Min Value of the wall thickness and the zone(s) where this is found. The Zone can be shown on the screen, but the Max and Min value reported in a Information window?
I know geometry property does it or Wall thickness analysis does it.. But they all give a range, not exact value ..
This is going to be used on a solid created by B surfaces.Like a housing
Thanks for the help..




