Printing Full size to Plotter, Prints out very Thick Lines.
Printing Full size to Plotter, Prints out very Thick Lines.
(OP)
I have a drawing I need to print out. The scale for the view is 1:4. The View also is set to smart lightweight.
When I try to print this to our plotter, using file print, I get very very thick lines. 3.9mm. I would like my lines to be thin and crisp.
I have attached an image how thick these lines are plotting.
What setting do I have wrong or can I change to get nice thin crisp line? I have tried UGII_WMF_LINE_WIDTH_SCALE_FACTOR=.25
The line thicknesses did not change at all.
Sorry using NX10
When I try to print this to our plotter, using file print, I get very very thick lines. 3.9mm. I would like my lines to be thin and crisp.
I have attached an image how thick these lines are plotting.
What setting do I have wrong or can I change to get nice thin crisp line? I have tried UGII_WMF_LINE_WIDTH_SCALE_FACTOR=.25
The line thicknesses did not change at all.
Sorry using NX10





RE: Printing Full size to Plotter, Prints out very Thick Lines.
www.nxjournaling.com
RE: Printing Full size to Plotter, Prints out very Thick Lines.
NX8.5 + TC8.3
RE: Printing Full size to Plotter, Prints out very Thick Lines.
RE: Printing Full size to Plotter, Prints out very Thick Lines.
So even if your width set for pen 1 is .13mm in NX but pen 1 in plotter is set to 4mm - line 4mm wide will be printed for all lines using pen 1.
NX8.5 + TC8.3