Drafting constraining cutting plane to hole
Drafting constraining cutting plane to hole
(OP)
I'm working on Catia v5 version 5-6 release 2012 service pack 5 build number 22.
Can I constrain a cutting plane to a hole so when I move the hole in the model it updates and move the cutting plane with the hole. See inclosed attachement. If this has already been addressed I'm sorry I spent an half an hour looking for it and couldn't find it.
thanks
Can I constrain a cutting plane to a hole so when I move the hole in the model it updates and move the cutting plane with the hole. See inclosed attachement. If this has already been addressed I'm sorry I spent an half an hour looking for it and couldn't find it.
thanks





RE: Drafting constraining cutting plane to hole
No attachment...can you upload a sample part? It would be easier...
Regards
Fernando
https://picasaweb.google.com/102257836106335725208 - Romania
https://picasaweb.google.com/103462806772634246699... - EU
RE: Drafting constraining cutting plane to hole
indocti discant et ament meminisse periti