Does ENSYS 3015AJ open programs made for FO4020NT. The drawings for the same are not being generated in ENSYS 3i controller when opened via SDD. It opens perfectly fine in F04020 via SDD. But when the same program is opened in ENSYS via SDD(connected to the same server as FO4020NT), it fails to generate the drawing. Is it because the length and breadth of ENSYS being smaller as compared to FO4020?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Since the later 1980s, manufacturing companies have seen over 3 percent in labor output year on year, with most of this productivty enhancement occuring because of the optimization of repetitive tasks. Download Now