Load Combinations for Ultimate Limit State
Load Combinations for Ultimate Limit State
(OP)
Hi!
I would like to include thermal(transient) loads due to pipe in my model. What would my load combinations look like?
Is this correct:
1.25DL + 1.4WL +1.25T + 0.5SL, where DL,WL, and T are Principal Loads and the SL is the companion load
Thanks!
I would like to include thermal(transient) loads due to pipe in my model. What would my load combinations look like?
Is this correct:
1.25DL + 1.4WL +1.25T + 0.5SL, where DL,WL, and T are Principal Loads and the SL is the companion load
Thanks!






RE: Load Combinations for Ultimate Limit State
RE: Load Combinations for Ultimate Limit State
RE: Load Combinations for Ultimate Limit State
I would be ok with 1.25D + 1.25T + 0.4W + 0.5S. That would be assuming your T is actually a short term type load not a permanent load and therefore W and S would be companion loading.
RE: Load Combinations for Ultimate Limit State