ABAQUS: Cutter does not move, help
ABAQUS: Cutter does not move, help
(OP)
Hi dear engineers!
Nice to meet you all. I am currently working on a project to study the wear rate of pdc cutter when drilling rock. I followed this video instruction tightly and expected the result to be similar to it. https://www.youtube.com/watch?v=tnyWxQYylZc However, after the simulation, the cutter just remain at the same spot and changes its colour repetitively. Anyone know what happen?

Nice to meet you all. I am currently working on a project to study the wear rate of pdc cutter when drilling rock. I followed this video instruction tightly and expected the result to be similar to it. https://www.youtube.com/watch?v=tnyWxQYylZc However, after the simulation, the cutter just remain at the same spot and changes its colour repetitively. Anyone know what happen?





