about iterative process in abaqus
about iterative process in abaqus
(OP)
Dear all
I have a question about my trying by Abaqus.
I want to load a surface by pressure and extract stresses and displacements of whole model. then i must have a iterative process that import displacements and stresses from previous iteration (stresses as pre-stresses in new iteration).
I don't know how i can do this process.
please help me
thanks in advanced
I have a question about my trying by Abaqus.
I want to load a surface by pressure and extract stresses and displacements of whole model. then i must have a iterative process that import displacements and stresses from previous iteration (stresses as pre-stresses in new iteration).
I don't know how i can do this process.
please help me
thanks in advanced





RE: about iterative process in abaqus
*********************************************************
Are you new to this forum? If so, please read these FAQs:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083
RE: about iterative process in abaqus
thanks for your attention and your reply
I did it but it take a long time. because i should these iteration till displacements will be near zero.
i want to know is there any easier way?
again thanks