Add Kinematic Model- Mold Wizard- NX 10
Add Kinematic Model- Mold Wizard- NX 10
(OP)
Hello All,
I have difficulty in using "Mold Wizard" in NX 10. When selecting "Preprocess Motion" in "Tooling Validation", there is no kinematic model shown in the dialog box. I tried also "set press model" in "Die validation" menu, it does not shown any "current Press model" and no "available press Models".
Could you please help me in this issue?
Regards,
Shah
I have difficulty in using "Mold Wizard" in NX 10. When selecting "Preprocess Motion" in "Tooling Validation", there is no kinematic model shown in the dialog box. I tried also "set press model" in "Die validation" menu, it does not shown any "current Press model" and no "available press Models".
Could you please help me in this issue?
Regards,
Shah





RE: Add Kinematic Model- Mold Wizard- NX 10
Probably you haven’t added mold base (Mold Wizard) to NX.
You must download mold base from Siemens:
https://download.industrysoftware.automation.sieme...
Regards
Marcin
RE: Add Kinematic Model- Mold Wizard- NX 10
Thanks a lot for the reply. I have it installed and can define regions and parting line,.... But not see any kinematic model at the end to preprocess the motion.
Sincerely,
Shah
RE: Add Kinematic Model- Mold Wizard- NX 10
Do You have catalog C:\....\NX10\MOLDWIZARD\templates\press_model?
Haw is the size of folder Moldwizard?
Without mold wizard library you can create parting line etc.
Regards,
Marcin