NX10 Tutorial
NX10 Tutorial
(OP)
Hello,
We are looking to roll out NX10 at my work and am looking for a good tutorial to either A) familiarize people who have used previous versions of NX with the changes in NX10 and B) a good starter tutorial for NX which utilizes NX10. I am not sure if I am asking too much, I know for the former I have seen similar for ProE but the latter it may be too early to find a good "Intro to NX" tutorial which utilizes NX10 as I understand it is quite new. PDF or powerpoint are preferred, however if there are good video tutorials I wouldn't mind checking those out either. Thanks for the help.
We are looking to roll out NX10 at my work and am looking for a good tutorial to either A) familiarize people who have used previous versions of NX with the changes in NX10 and B) a good starter tutorial for NX which utilizes NX10. I am not sure if I am asking too much, I know for the former I have seen similar for ProE but the latter it may be too early to find a good "Intro to NX" tutorial which utilizes NX10 as I understand it is quite new. PDF or powerpoint are preferred, however if there are good video tutorials I wouldn't mind checking those out either. Thanks for the help.
Jarrett





RE: NX10 Tutorial
______
Alex ,
RE: NX10 Tutorial
Link
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: NX10 Tutorial
RE: NX10 Tutorial
I used
www.gocadserve.com
To do an on-site two day what's new class. For our NX8.5 upgrade.
It was very good.
RE: NX10 Tutorial
Jarrett