Decompressing the cold runner, liquid silicone rubber injection molding
Decompressing the cold runner, liquid silicone rubber injection molding
(OP)
Hello,
Does anyone know why LSR molders typically decompress the cold runner *after* the valve gates are closed?
I can understand this practice with open nozzles, but don't know why it's also done with valved ones.
Thanks,
Does anyone know why LSR molders typically decompress the cold runner *after* the valve gates are closed?
I can understand this practice with open nozzles, but don't know why it's also done with valved ones.
Thanks,





RE: Decompressing the cold runner, liquid silicone rubber injection molding