Duct sizing Program
Duct sizing Program
(OP)
Hi,
I am contemplating to buy a duct sizing program. I am evaluating various programs, but it is hard to make a decision. Elite has DUCTSIZE, which I think will suit my requirements. I want to hear from you if you have any experience with it. OR for that matter which one do you use and how do you find it.
regards,
Vicsidhu
I am contemplating to buy a duct sizing program. I am evaluating various programs, but it is hard to make a decision. Elite has DUCTSIZE, which I think will suit my requirements. I want to hear from you if you have any experience with it. OR for that matter which one do you use and how do you find it.
regards,
Vicsidhu





RE: Duct sizing Program
RE: Duct sizing Program
I have those ductulators and the software. McQuay has these as tools on their web site - they have small programs for more than just ducts.
I am looking for a more extensive program, where I can put in the whole layout, change it if and when needed, and get all the pressure drops and Noise calculations for all the paths. Not to mention the total E.S.P for the system.
Right now I am doing all this maually and it is such a pain to do it when small changes come in. Even though I have given up my practice to go with actual duct losses at all the components and have resloved to just Equivalent length method, I spend a lot of time. There are programs available which will do all mental labour for you. Now that I know the basics, I want to move on to being more efficient.
regards,
Vicsidhu
RE: Duct sizing Program
RE: Duct sizing Program
http://www.connel.net/freeware/airduct.shtml
Hope this helped
Jp
RE: Duct sizing Program
How are you determining the Lossess thru a reducer duct. When u calculate the static loss in the duct, equal friction method, how do u work out the loss in a total system (starting from an AHU Outlet till the last air outlet) is it by piece by piece.. (straigt duct, reducer, elbow..etc..) Please LET ME KNOW HOW TO CALCULATE FRICTION LOSS IN A "REDUCER" DUCT.
Thanks.
Ragu.