NX10 active sketch view
NX10 active sketch view
(OP)
I'm trying to create a view breakout in NX10 in drafting, but I'm unable to make the view the active sketch view, I can't find the option anywhere. Am I missing something?
many thanks
Si
many thanks
Si
Best regards
Simon
NX7.5 NX8.5 NX9 NX10
NX Consultant
www.team-eng.com





RE: NX10 active sketch view
Perhaps the view of interest is a Detailed View. If so, you need to select the Detailed View, press MB3 and select the 'Convert to Independent View' option first, then you can go back, re-select the view, press MB3 and you should now findthe 'Active Sketch View' option.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX10 active sketch view
I sure am going to miss that valve of yours.
RE: NX10 active sketch view
http://www.plmworld.org/p/cm/ld/fid=237
...you'll see that I've been using this model since 1983, and if you scroll to near the end, you'll see a few more examples of this model.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX10 active sketch view
I worked it our in the end, the view I was trying to create the break out section on already had a broken view applied to it, so The break out had to be either be created first, or the broken view had to be suppressed, or the curves had to be added in the expanded view.
Many thanks for your assistance
Si
Best regards
Simon
NX7.5 NX8.5 NX9 NX10
NX Consultant
www.team-eng.com