Megger BITE3 reads "Out of range" when measuring cell and strap impedance. Cell voltage readings are within range 12-13vdc. The strap connectors are not solid bus bar, rather the standard battery cables in parallel (2) per post. How do I resolve the "Out of Range" issue? All (40) batteries are displaying the same message.
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
PCB design is a purposeful process. In essence, every PCB design is a complex puzzle that requires a designer to incorporate critical components and tight schematics into a piece of technology that is governed by rules, constraints and industry standards. Download Now