Analysing and designing large mechanical assemblies
Analysing and designing large mechanical assemblies
(OP)
Hi,
I was just wondering how many of you out there are performing FEA and design of large mechanical assemblies.
What are there the specific problems from your point of view?
I will start by saying, that in the traditional FEA software every design change requires reimporting the whole CAD assembly and more or less starting from zero again. I'm starting with this this point, because this the main focus in my company.
But I would also like to hear your opinion as experienced user.
Thank you very much!
Alex
I was just wondering how many of you out there are performing FEA and design of large mechanical assemblies.
What are there the specific problems from your point of view?
I will start by saying, that in the traditional FEA software every design change requires reimporting the whole CAD assembly and more or less starting from zero again. I'm starting with this this point, because this the main focus in my company.
But I would also like to hear your opinion as experienced user.
Thank you very much!
Alex
Best regards
Alexandru Dadalau
MESHPARTS GmbH
Tuning Your Simulation
http://www.meshparts.de





RE: Analysing and designing large mechanical assemblies
Best regards
Alexandru Dadalau
MESHPARTS GmbH
Tuning Your Simulation
http://www.meshparts.de