edit location of text leader NX(
edit location of text leader NX(
(OP)
Working in NX9 and having an issue reassociating a leader from an ID symbol and text or note.
when attempting to reassociate to an edge of a diameter (ie washer) or possibly a radius, when reselecting the terminating object the diameter circle appears and wants to place the tip of the arrow on the arc center. This is extremely frustrating. So far I can only redo it by deleting the symbol or note and redo it. There must be a better way that is a hidden option in NX9. hope I explained it well enuff.
Any ideas would be greatly appreciated.
when attempting to reassociate to an edge of a diameter (ie washer) or possibly a radius, when reselecting the terminating object the diameter circle appears and wants to place the tip of the arrow on the arc center. This is extremely frustrating. So far I can only redo it by deleting the symbol or note and redo it. There must be a better way that is a hidden option in NX9. hope I explained it well enuff.
Any ideas would be greatly appreciated.
Wayne Huseby
Drafting Checker
Goodrich Corp
Jamestown, ND 58401





RE: edit location of text leader NX(
www.nxjournaling.com
RE: edit location of text leader NX(
Thanks again. One less frustrating NX9 drafting issues to deal with.
Wayne Huseby
Drafting Checker
Goodrich Corp
Jamestown, ND 58401
RE: edit location of text leader NX(
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: edit location of text leader NX(
www.nxjournaling.com