Norsok M-650
Norsok M-650
(OP)
Hi I’m relatively new to Norsok requirements on oil & gas equipment. My understanding is that material to be used shall come from a Norsok Qualified mill according to M-650. This mill would need to have a QTR certificate for each type of material.
I’m being told that if I get the steel from a Norsok approved mill (with QTR certificate) and machine this material at another manufacturing facility that I also need a Norsok M650 qualification for that facility. Can you anyone advise is this is correct?
I’m being told that if I get the steel from a Norsok approved mill (with QTR certificate) and machine this material at another manufacturing facility that I also need a Norsok M650 qualification for that facility. Can you anyone advise is this is correct?





RE: Norsok M-650
Steve Jones
Corrosion Management Consultant
http://www.linkedin.com/pub/8/83b/b04
All answers are personal opinions only and are in no way connected with any employer.