Issue Related to TeamCenter
Issue Related to TeamCenter
(OP)
Hello All,
Actually I have some parts created outside TeamCenter. The drawings for these parts have been created using Master Model Concept. Now it is required to Import these parts into TeamCenter. When I am trying to do this, parts are getting imported but drawings are getting rejected. Can somebody describe me the procedure on how this is actually done.
I am using UG Nx9
Thanks in Advance.
Actually I have some parts created outside TeamCenter. The drawings for these parts have been created using Master Model Concept. Now it is required to Import these parts into TeamCenter. When I am trying to do this, parts are getting imported but drawings are getting rejected. Can somebody describe me the procedure on how this is actually done.
I am using UG Nx9
Thanks in Advance.




