Bugs in ST8
Bugs in ST8
(OP)
ST8 seems to have quite a few bugs in my experience.
Test not visable in dimensions. Extrude command fails in all parts whe working in ordered mode. The latter can be fixed by generating new part and making a base extrusion. After that there is no problem until issue pops up again.
I'm woring from MP2. I thought most issues would be sorted by now.
Test not visable in dimensions. Extrude command fails in all parts whe working in ordered mode. The latter can be fixed by generating new part and making a base extrusion. After that there is no problem until issue pops up again.
I'm woring from MP2. I thought most issues would be sorted by now.





RE: Bugs in ST8
RE: Bugs in ST8
Most of issues are fairly small like display problems. However they are very annoying and time consuming. I am not geting much help from tec. support.
I wonder is it because I am working in ordered mode?
RE: Bugs in ST8
As for the extrude command failing in any mode I have not experienced or heard about.
Bruce Shand
ST8 MP5
RE: Bugs in ST8
Only problem I had was in one part which wouldn't update unless SE restarted. Luckely it wasn't too complicated so I made up new version.