NX nastran simulating fluid in an open tank using NLstatic 106
NX nastran simulating fluid in an open tank using NLstatic 106
(OP)
Dear All,
I'm trying to solve a case where fluid is acting as a force on a open tank. I've read the NX nastran 8 Advanced Dynamic analysis User's guide, about Virtual fluid mass. And searched for some more information about MAT10 en Mfluid parameters in NX nastran quick reference guide.
I found some more information on this forum : https://community.plm.automation.siemens.com/t5/NX...
Is it correct that setting up (with the NX GUI) this perticular case in NX advanced simulation is not possible?
It would be very helpfull for me to have a some sort of example about setting up this kind of cases.
I'm trying to solve a case where fluid is acting as a force on a open tank. I've read the NX nastran 8 Advanced Dynamic analysis User's guide, about Virtual fluid mass. And searched for some more information about MAT10 en Mfluid parameters in NX nastran quick reference guide.
I found some more information on this forum : https://community.plm.automation.siemens.com/t5/NX...
Is it correct that setting up (with the NX GUI) this perticular case in NX advanced simulation is not possible?
It would be very helpfull for me to have a some sort of example about setting up this kind of cases.
Siemenx NX8 - Teamcenter 8.5 Windows 7




