Switch Part Tool doesn't work anymore
Switch Part Tool doesn't work anymore
(OP)
Hi,
I have been using NX Switch Part Tool from 2013 (http://www.eng-tips.com/viewthread.cfm?qid=351988)
And It worked very well, but now I have the following message in NX8.5, NX9 and NX10

Any Idea ?
TIA
I have been using NX Switch Part Tool from 2013 (http://www.eng-tips.com/viewthread.cfm?qid=351988)
And It worked very well, but now I have the following message in NX8.5, NX9 and NX10

Any Idea ?
TIA
Regards
Didier Psaltopoulos
http://www.psi-cad.com





RE: Switch Part Tool doesn't work anymore
NXSwitchPart.vb
I've been meaning to get this on my toolbars for a while, but I forgot about it until I saw this post. I just switched out some of the
CODE --> vb
CODE --> vb
DHuskic
Nx8.5 & Nx9.0
RE: Switch Part Tool doesn't work anymore
Thanks a lot
Regards
Didier Psaltopoulos
http://www.psi-cad.com