NX 7.5.5.4 Part Families
NX 7.5.5.4 Part Families
(OP)
Hello all,
I want to use Linked Body to create part families but after i unite the Body with the Linked Body to create the 4 pole version,
the Linked Body becomes the 4 pole. And when created it becomes a 4 pole instead a 3 pole
Is there a solution for this problem?
Thank you for your time
I want to use Linked Body to create part families but after i unite the Body with the Linked Body to create the 4 pole version,
the Linked Body becomes the 4 pole. And when created it becomes a 4 pole instead a 3 pole
Is there a solution for this problem?
Thank you for your time





RE: NX 7.5.5.4 Part Families
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.