How to create a flat view of a part in a drawing
How to create a flat view of a part in a drawing
(OP)
Hi,
I've created a curved part by:
1. Wave linking in the mating surface from my other part.
2. Creating a flat sketch.
3. Wrapping the curves onto my cylindrical surface.
4. Using through curves to create a sheet.
5. Thickened sheet.
So how can I take that part, and show it flattened in a drawing view. I've attached a picture to show my part. Thanks!
Alex
I've created a curved part by:
1. Wave linking in the mating surface from my other part.
2. Creating a flat sketch.
3. Wrapping the curves onto my cylindrical surface.
4. Using through curves to create a sheet.
5. Thickened sheet.
So how can I take that part, and show it flattened in a drawing view. I've attached a picture to show my part. Thanks!
Alex
Design Drafter
Orbital Atk





RE: How to create a flat view of a part in a drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: How to create a flat view of a part in a drawing
I guess the reason I wanted to use my solid was because I wanted a side view to show the thickness. Dumb question, how do I use my sketch from modeler in drafting as my flat view?
Thanks
Design Drafter
Orbital Atk
RE: How to create a flat view of a part in a drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: How to create a flat view of a part in a drawing
Design Drafter
Orbital Atk