NX9 Drawing Size
NX9 Drawing Size
(OP)
All,
I have been working on a old NX7.5 drawing 'UGPART' whcih has now been revised using NX9.
Only minor changes have bee made to the drawing (a few notes and a composite section view)
The part file has jumped from 45mb to 111mb
Does anyone have any experience of this, is there a work around, is it a known issue?
cheers in advance,
NX Jockey
I have been working on a old NX7.5 drawing 'UGPART' whcih has now been revised using NX9.
Only minor changes have bee made to the drawing (a few notes and a composite section view)
The part file has jumped from 45mb to 111mb
Does anyone have any experience of this, is there a work around, is it a known issue?
cheers in advance,
NX Jockey





RE: NX9 Drawing Size
Did you use refile (in NX9)?
Best Regards
Kapil
RE: NX9 Drawing Size
RE: NX9 Drawing Size
RE: NX9 Drawing Size
www.nxjournaling.com