Hide mesh after cfd analyses in result
Hide mesh after cfd analyses in result
(OP)
As the title says can i hide (not supres) the mesh in my results so the i can see the flow lines better ?
my fluidum box is pretty big while the mesh is small for some lements inside. i already found an older topic but it doesnt seem to help in NX 10 http://www.eng-tips.com/viewthread.cfm?qid=370163
someone ?
my fluidum box is pretty big while the mesh is small for some lements inside. i already found an older topic but it doesnt seem to help in NX 10 http://www.eng-tips.com/viewthread.cfm?qid=370163
someone ?





RE: Hide mesh after cfd analyses in result
Regards,
Tomas