NX 10 - Object Snap reset
NX 10 - Object Snap reset
(OP)
Hello,
I could able to see only the 'enable and disable' icon in the Object snap Selection intent.
How to get back the 'reset snap' icon back, which was available earlier?
Thanks,
Mathi K
I could able to see only the 'enable and disable' icon in the Object snap Selection intent.
How to get back the 'reset snap' icon back, which was available earlier?
Thanks,
Mathi K





RE: NX 10 - Object Snap reset
Are you asking about CLEAR SNAP POINT ?
You can drag and drop it from the customization dialog box as shown in the picture attached.
Best Regards
Kapil