highlighted parts
highlighted parts
(OP)
Hello all!
Something has started to annoy me and i'm sure there must be a way around it.
I am drafting and i have a large assembly, i am using the 'hide components in view' command, i select a few components and then it highlights the full assembly, you have to wait for it to 'un-highlight' and then you can carry on, is there a way to get around this?
Thanks
James
Something has started to annoy me and i'm sure there must be a way around it.
I am drafting and i have a large assembly, i am using the 'hide components in view' command, i select a few components and then it highlights the full assembly, you have to wait for it to 'un-highlight' and then you can carry on, is there a way to get around this?
Thanks
James





RE: highlighted parts
RE: highlighted parts
Yeah thats faster, just easier to pick them from the drawing view when you have hundreds of parts, maybe its not something that can be done though
RE: highlighted parts
www.nxjournaling.com