"Some lightweight representations" message
"Some lightweight representations" message
(OP)
Hello everyone!
In NX8.5 assembly one of the components, when switched to lightweight representations shows partially shaded feather and reports "Some lightweight representations" instead of "All lightweight representations". I could not find the reason. How to fix it? Where to have a look?
In NX8.5 assembly one of the components, when switched to lightweight representations shows partially shaded feather and reports "Some lightweight representations" instead of "All lightweight representations". I could not find the reason. How to fix it? Where to have a look?





RE: "Some lightweight representations" message
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: "Some lightweight representations" message
No, it's not. It contains solid bodies and some UDF's, which in turn consist of solid and sheet bodies. But other similar components are in full lightweight reperentation.
www.cadroad.com
RE: "Some lightweight representations" message
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: "Some lightweight representations" message
I already tried to delete and re-create lightweight representations in a file but it did not help. That's why I an a bit confused.
www.cadroad.com