Abaqus convergence
Abaqus convergence
(OP)
Dear all
I do a compression simulation with one end is fixed and one end is compressed controlled by velocity, for example -10mm/s for 2 seconds expecting a displacement -20mm in total.
However, time converges around 0.6s by increasing increments.
Do you have an idea how to reach the deformation I gave?
I do a compression simulation with one end is fixed and one end is compressed controlled by velocity, for example -10mm/s for 2 seconds expecting a displacement -20mm in total.
However, time converges around 0.6s by increasing increments.
Do you have an idea how to reach the deformation I gave?





RE: Abaqus convergence
*********************************************************
Are you new to this forum? If so, please read these FAQs:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083